December 27, 2018

For some time now I've wanted to upgrade my Harbor Freight Mini Mill with a digital readout system.  These low-end mills have a lot of backlash in the lead screws and the dials on the feed wheels are also somewhat questionable and very cumbersome to use.  You can certa...

December 15, 2018

It's been a long and educational road, but the two Pride design knives are now complete and available over on the Available Knives & Gear page.  Below are a few pics of the finished knives.  Can you pick a favorite?

There are a couple of videos of these two knives...

December 11, 2018

Greetings, everyone and welcome back to the duo Pride knife build.  This week I was able to get the two knives practically finished.  They turned out even better than I had anticipated.  I'm truly proud of these two pieces.  Unfortunately, I got so wrapped up in the bu...

December 2, 2018

I love this time in a knife build.  The parts are all profiled, everything is  shaped, and the parts are all fit and tight.  It's time for some detail work and to start on the blades.  I spent my shop time working on the pearl handle knife. I'll have to get to the carb...

Please reload

Featured Posts

Progress on the Bench

December 3, 2019

1/10
Please reload

Recent Posts

December 3, 2019

September 25, 2019

September 16, 2019

September 3, 2019

August 13, 2019

Please reload

Archive
Please reload